Andddd continuing
Got the Koyo and FAL Pusher Fans and DIF Controller in ^_^
EDIT: DIF controller D&C do not seem to hold up well with FAL's due to the high Amp draw, I already burned mine up after 5 months,
I would however recommend the DIF PWM Fan Controller which is reated at 60Amps and much more efficient and maintain's a more steady temp rather than fluctuating temps like the D&C
DIF PWM on the left
![](http://i73.photobucket.com/albums/i235/Neil_85/Miyukis%20Silvia/DSCN3712.jpg)
Enjuku actually sent me pullers rather than Pushers, but I called FAL and they sent me some pusher blades for free. ^_^
I was planing on waiting to do it when i swap in the RB but the old one was cracking and rotting away.
Ewwwwww.....
Put the wife to work again on this one.
![](http://i73.photobucket.com/albums/i235/Neil_85/Miyukis%20Silvia/DSCN3557.jpg)
Installed
Good Job Honey!
Then ended up cleanin up the tranny a little bit.
I need a clutch that could hold some TQ but soft enough for my Wife to drive it, so i decided on the
Exedy Stage 1 Clutch
I had planned on using the the stock flywheel but it was pretty haggard when i pulled the clutch off of it.
I cleaned it up had it machined. (may not look it but its alot cleaner) The FW was pitted pretty bad so they had to machine it a good bit which is one reason I decided to get a new flywheel.
But not only was the condition of the FW the reason I decide to get another one but I remembered on my R33 the Revs were seemed kinda slow on the Rev and Recovery
Then I You tubed a vid of one that sold me on it.
YouTube - ER34 RB25DET Blipping with Lightweight Flywheel
![](http://i73.photobucket.com/albums/i235/Neil_85/Miyukis%20Silvia/DSCN3693.jpg)
The Combined with an Exedy Stage 1 Kit= Sex
![](http://i73.photobucket.com/albums/i235/Neil_85/Miyukis%20Silvia/DSCN3698.jpg)