Quote:
Originally Posted by DFWZenki
That sucks. I was about to try it myself but i was hoping it would be easier. Thanks for the info.
About the resistor wiring. Let me try to make this simple.
You have a Positive lead (wires coming off the LED bulb) and a Negative Lead.
1)The Proper Resistor is placed between your power source and the Positive Lead on the LED bulb.
2)The Negative Lead is connected to your Negative connection (opposite post from resistor).
3)If no resistor is used they will burn out very quickly.
4)Below are some rough examples of LEDs with resistors. You should always solder your connections for the best results.
|
THANKS SO MUCH FOR THE PICS!
exactly what i wanted. thanks again.
one question tho, it seems so simple that im not sure about it. could you put the resistor on the 12v wiring going TO the button out side of the actual button? i know the fsm shows which wires are positive and which ones are negative going to the button. im just not 100% sure.