NC JDM OEM S13 Din Gauges. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

ShiftOtaku · 11-03-2009, 12:34 AM

JDM 3gauge DIN pod, OEM in 98 Silvia K's Aero models.
Volt, Oil Pressure, and Boost.
Asking $120.00 Shipped.

These are in working condition. How to make them work in your S13:

Black w/ silver dots-ground
green-ignition
black-illumination dimmer
red/blue-illumination
yellow/red-oil pressure sensor
black/pink-boost sensor

Buy a Z32 oil pressure sending unit and install it in place of the OE switch, ground one side and feed the other to the gauge input.

The boost sensor uses a voltage reference. So you will have to buy an after market electronic boost sender, or get one from a Z32.

ShiftOtaku · 11-04-2009, 11:08 PM

New prices $90.00 Shipped.

Triple R S13 · 11-05-2009, 12:52 AM

is this too big to fit in HVAC spot on bezel?

ShiftOtaku · 11-05-2009, 01:14 AM

Yeah, has to go in one of the two lower spots.

*WakeBHR* · 11-05-2009, 02:32 AM

what wire in the harness goes to voltage?

Triple R S13 · 11-05-2009, 02:50 AM

Quote:

Originally Posted by WakeBHR

what wire in the harness goes to voltage?

the ign 12v wire... same thing...

*WakeBHR* · 11-05-2009, 02:51 AM

thought so I just wasnt sure

st*ner moment

11-03-2009, 12:34 AM	#1
ShiftOtaku Join Date: Apr 2009 Location: Asheville, NC Age: 22 Posts: 11 Trader Rating: (0)	JDM OEM S13 Din Gauges. JDM 3gauge DIN pod, OEM in 98 Silvia K's Aero models. Volt, Oil Pressure, and Boost. Asking $120.00 Shipped. These are in working condition. How to make them work in your S13: Black w/ silver dots-ground green-ignition black-illumination dimmer red/blue-illumination yellow/red-oil pressure sensor black/pink-boost sensor Buy a Z32 oil pressure sending unit and install it in place of the OE switch, ground one side and feed the other to the gauge input. The boost sensor uses a voltage reference. So you will have to buy an after market electronic boost sender, or get one from a Z32.

11-05-2009, 12:52 AM	#3
Triple R S13 Zilvia Member Join Date: Dec 2008 Location: Del-a-Where? Age: 19 Posts: 219 Trader Rating: (3)	is this too big to fit in HVAC spot on bezel? __________________ DELDRFT!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Sponsored Links
Remove these by purchasing a Premium Membership with Zilvia.net!

11-04-2009, 11:08 PM	#2
ShiftOtaku Join Date: Apr 2009 Location: Asheville, NC Age: 22 Posts: 11 Trader Rating: (0)	New prices $90.00 Shipped.

11-05-2009, 01:14 AM	#4
ShiftOtaku Join Date: Apr 2009 Location: Asheville, NC Age: 22 Posts: 11 Trader Rating: (0)	Yeah, has to go in one of the two lower spots.