Where do I place censor? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

EmKayThree · 02-25-2009, 12:53 PM

Problem

So my car shuts off because my rpm drops too low.
I was told that my air/fuel ratio mixture is not correct.
Where do I place the sensor that is hooked up to my boost controller?

Before the manifold but after the blow-off valve, or what?

Would I need a special drillbit to drill into the piping (I like to do things myself).

Sileighty_85 · 02-25-2009, 12:58 PM

LOL

The boost controller sensor has nothing to do with that

either re-circulate the BOV or Tighten down the the Adj. screw on it

Check for Boost leaks

deadpirate · 02-25-2009, 04:55 PM

censors cover naughty places

EmKayThree · 02-27-2009, 12:35 PM

In that case, where would I place the Boost Controller Sensor then? I haven't even put it in yet.

Sileighty_85 · 02-27-2009, 12:51 PM

Any Vacum source on the charge piping/Intake manifold

02-25-2009, 12:53 PM	#1
EmKayThree Join Date: Feb 2009 Location: Los Angeles Age: 22 Posts: 34 Trader Rating: (0)	Where do I place censor? Problem So my car shuts off because my rpm drops too low. I was told that my air/fuel ratio mixture is not correct. Where do I place the sensor that is hooked up to my boost controller? Before the manifold but after the blow-off valve, or what? Would I need a special drillbit to drill into the piping (I like to do things myself).

02-25-2009, 12:58 PM	#2
Sileighty_85 Nissanaholic! Join Date: Dec 2006 Location: Wishing Back in Okinawa -_- Posts: 2,497 Trader Rating: (0)	LOL The boost controller sensor has nothing to do with that either re-circulate the BOV or Tighten down the the Adj. screw on it Check for Boost leaks __________________ 後輪駆動車１番 1991 Built SR GT2871R -363whp 1998 S14 W/RB25- Rebuild in Progress

02-25-2009, 04:55 PM	#3
deadpirate Zilvia FREAK! Join Date: Nov 2006 Location: riverside..yea broooo Age: 23 Posts: 1,187 Trader Rating: (2)	censors cover naughty places __________________ On Track Motorsport Supply-saftey stuff call TOM @ (805)484-3435

02-27-2009, 12:51 PM	#5
Sileighty_85 Nissanaholic! Join Date: Dec 2006 Location: Wishing Back in Okinawa -_- Posts: 2,497 Trader Rating: (0)	Any Vacum source on the charge piping/Intake manifold __________________ 後輪駆動車１番 1991 Built SR GT2871R -363whp 1998 S14 W/RB25- Rebuild in Progress

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Sponsored Links
Remove these by purchasing a Premium Membership with Zilvia.net!

02-27-2009, 12:35 PM	#4
EmKayThree Join Date: Feb 2009 Location: Los Angeles Age: 22 Posts: 34 Trader Rating: (0)	In that case, where would I place the Boost Controller Sensor then? I haven't even put it in yet.