CO 1989 240sx - Cage, Kit, etc etc - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

CO240 · 11-12-2009, 12:43 PM

I have spent a lot of time and money getting this car to where it is now. It runs and drive just fine. The interior has been taken out and it also has a MOMO racing bucket seat and NRG detachable racing steering wheel. A Simpson 5 point latch and link harness come on the drivers side and a Sparco 4 point harness on the passenger side. The top of the car is unpainted but already ready to spray. I decided to leave it up to the buyer whether to paint it green as the rest of the car or go with black ( I will throw in the rest of the green paint and clear coat I have, which is a bit less than half a gallon ). I also have a 180sx Type X Kouki wing that will come with the car if the buyer wants it which is already painted.

Oil was changed often. It was only driven a few times a month for the last 2 or 3 years.

The only problems are that the headlight motors, windshield wipers and speedometer dont work. The passenger side rear upper control arm could use a new heim joint ( cheap fix ). The car had wiring work done and new wires have to be run for these to work again.

Id like to get $$9.5k but price is OBO

Not looking for trades.

Motor:
SR20DET
10psi Actuator
Front Mount Intercooler
HKS intake
Synchronic BOV
Greddy Rocker Arm Stoppers
Greddy Oil Pan
Odyssey Battery
Apex Exhaust

Suspension:
Stance Coilovers
Suspension Techniques Sway Bars
SPL Tension Rods
SPL Traction Rods
SPL Toe Rods
ProjectSilvia Rear Upper Control Arms
RSR Bushing Set
Tein Tie Rods/Ends
Delrin Solid Subframe Bushings

Chassis:
MAC Autosport custom 8pt Roll Cage
Ultra Racing Fender Braces

Wheels/Brakes/Drivetrain:
ACT Street Clutch
Tomei 2 Way LSD
Z32 TT 5 Lug Swap w/Front and Rear Calipers
SPL Steel Braided Brake Line
Hawk HPS Pads
MB Battles 17x9.5 +15

Body:
Chaser Aero Kit
British Racing Green
180sx Type X Tail Lights
180sx Type X Wing

If buyer is interested... I have all parts needed to produce 400+whp, a package deal can be worked out if there is interest. I will part out otherwise.

Ill get an updated pic of the engine bay better shots of the cage later on..

CO240 · 11-16-2009, 10:45 AM

Bump!

msg lengh

CO240 · 11-20-2009, 09:28 AM

If someone wants so buy the car for the 9.5 I will throw in the following

Garrett GT3071r-wg Turbo (Brand New)
BC 264/264 Cams (Brand New)
JGY Top Feed Fuel Rail ( Brand New )
MAP ECU ( Brand New )
Precision Top Feed 72lb Injectors( about 5k miles used ) w/new sr20 pigtails
Circuit Sports Turbo Lines ( Brand New )
12' Electric Fan ( Brand New )

CO240 · 11-27-2009, 07:29 PM

Last Bump!!

Sad s13 · 11-27-2009, 07:37 PM

hey what size tires are you running?

CO240 · 11-30-2009, 09:49 AM

225/45 in the front

235/45 in the rear

11-12-2009, 12:43 PM	#1
CO240 Leaky Injector Join Date: Oct 2005 Location: Colorado Posts: 146 Trader Rating: (1)	1989 240sx - Cage, Kit, etc etc I have spent a lot of time and money getting this car to where it is now. It runs and drive just fine. The interior has been taken out and it also has a MOMO racing bucket seat and NRG detachable racing steering wheel. A Simpson 5 point latch and link harness come on the drivers side and a Sparco 4 point harness on the passenger side. The top of the car is unpainted but already ready to spray. I decided to leave it up to the buyer whether to paint it green as the rest of the car or go with black ( I will throw in the rest of the green paint and clear coat I have, which is a bit less than half a gallon ). I also have a 180sx Type X Kouki wing that will come with the car if the buyer wants it which is already painted. Oil was changed often. It was only driven a few times a month for the last 2 or 3 years. The only problems are that the headlight motors, windshield wipers and speedometer dont work. The passenger side rear upper control arm could use a new heim joint ( cheap fix ). The car had wiring work done and new wires have to be run for these to work again. Id like to get $$9.5k but price is OBO Not looking for trades. Motor: SR20DET 10psi Actuator Front Mount Intercooler HKS intake Synchronic BOV Greddy Rocker Arm Stoppers Greddy Oil Pan Odyssey Battery Apex Exhaust Suspension: Stance Coilovers Suspension Techniques Sway Bars SPL Tension Rods SPL Traction Rods SPL Toe Rods ProjectSilvia Rear Upper Control Arms RSR Bushing Set Tein Tie Rods/Ends Delrin Solid Subframe Bushings Chassis: MAC Autosport custom 8pt Roll Cage Ultra Racing Fender Braces Wheels/Brakes/Drivetrain: ACT Street Clutch Tomei 2 Way LSD Z32 TT 5 Lug Swap w/Front and Rear Calipers SPL Steel Braided Brake Line Hawk HPS Pads MB Battles 17x9.5 +15 Body: Chaser Aero Kit British Racing Green 180sx Type X Tail Lights 180sx Type X Wing If buyer is interested... I have all parts needed to produce 400+whp, a package deal can be worked out if there is interest. I will part out otherwise. Ill get an updated pic of the engine bay better shots of the cage later on..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Sponsored Links
Remove these by purchasing a Premium Membership with Zilvia.net!

11-16-2009, 10:45 AM	#2
CO240 Leaky Injector Join Date: Oct 2005 Location: Colorado Posts: 146 Trader Rating: (1)	Bump! msg lengh

11-20-2009, 09:28 AM	#3
CO240 Leaky Injector Join Date: Oct 2005 Location: Colorado Posts: 146 Trader Rating: (1)	If someone wants so buy the car for the 9.5 I will throw in the following Garrett GT3071r-wg Turbo (Brand New) BC 264/264 Cams (Brand New) JGY Top Feed Fuel Rail ( Brand New ) MAP ECU ( Brand New ) Precision Top Feed 72lb Injectors( about 5k miles used ) w/new sr20 pigtails Circuit Sports Turbo Lines ( Brand New ) 12' Electric Fan ( Brand New )

11-27-2009, 07:29 PM	#4
CO240 Leaky Injector Join Date: Oct 2005 Location: Colorado Posts: 146 Trader Rating: (1)	Last Bump!!

11-27-2009, 07:37 PM	#5
Sad s13 Zilvia Member Join Date: Apr 2007 Location: the real socal NOT LA Age: 22 Posts: 224 Trader Rating: (6)	hey what size tires are you running?

11-30-2009, 09:49 AM	#6
CO240 Leaky Injector Join Date: Oct 2005 Location: Colorado Posts: 146 Trader Rating: (1)	225/45 in the front 235/45 in the rear