HonduhToyoKiller

"Engine" :

* * The engine provides the energy to propel (move) the vehicle and operate the other systems .Most engine consume gasoline or diesel fuel (in the case of 240SX owners :"fuel").The fuel burns in the engine to produce heat.This heat causes gas expansion ,creating pressure inside the engine.The pressure moves internal engine parts to produce power. *

The engine is usually located in the front portion of the body .Placing the heavy engine in this position makes the vehicle safer in the even of a head -on collision (accident) . In a few vehicles ,the engine is mounted in the rear to improve handling. *

Basic engine parts

"In line 4 cilinder show"

The block: is a metal casting that holds all the other engine parts in place .


The cilinder : is round hole bored (machined) in the block.It guides the piston movement.



As you can see in left side of the picture ,the are 4 round cilinders . This image is showing what an engine block could look!

The piston : is a cilindrical component that transfer the energy of combustion (burning air-fuel mixture) to the connecting rod.



As you can see this is a piston image ,behind it you can see the
"Connecting Rod" .

The rings : seal the small gap around the sides of the pistons .They keep combustion pressure and oil from leaking between the piston and the cilinder wall (cilinder surface) .

The connecting rod : it links the piston to the crank shaft .

The crankshaft : changes the reciprocating ( up and down ) motion of the piston and rod into useful rotary (spinning) motion .


I have not finished so pls is you read this post pls dont reply at this time ,thanx : "Honduh"

__________________
I rather push a Nissan than drive an Honda .
If GOD was not merciful Honda would not have been existed!
One of the most sad reasons we should envy japanese Silvia S15 owners : " they cant count their gears with one hand"

AIManny184